[. . . ] Notes: - In case of power failure the cold accumulator helps to keep optimal storage temperature longer. - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. - The appliance accessories are not suitable for washing in dishwasher. [. . . ] The indicator lamps on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: • if food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. • If fresh food is loaded in freezer position 3 on control panel should be chosen. CONTROL PANEL DESCRIPTION low temperature extra low temperature Description Lamp OFF Lamp ON GUIDE TO SELECTING FUNCTIONS Temperature selection / stand-by pushbutton is used to set desired temperature level, from warmest through lower to coldest . Stand-by / ON function To put the appliance in Stand-by state press and hold Temperature selection / stand-by pushbutton for 3 seconds. Note: When the product is in stand-by mode the light operates normally, all other loads are disabled and control panel shows no indication. When the appliance has to be left for a longer period with fridge door open to avoid odour, power cord has to be unplugged from the power supply. To switch on the product when it is in Stand-by state, press Temperature selection / stand-by pushbutton. Appliance comes back to normal operation, control panel displays previously chosen setpoint. An internal container, with an active carbon filtered ensures water filtration. To fill the tank: rotate the water inlet towards you and fill with water, using a jug or other suitable container. Once the tank is full, close the water inlet by moving it back to its original position. Always use drinking water only: any other liquid may impair product performance. Stop Water drip tray Fig. 2) After filling the tank, the water may not be immediately available. This is because the filtering process may require a few minutes (depending on the amount of water in the tank). To dispense water: with the refrigerator door closed, press the water dispenser tab with the glass. If for safety reason water delivery must be prevented, simply press the stop at the back of the tab. To release water delivery move the stop back to its original position. It is recommended to drink the supplied water from the dispenser in 6 hours. [. . . ] Twice a year it is recommended to keep healthy the unit using specific products based on diluted chlorine that not modify the material properties and rinse with current water. 4) release and remove the water tank by lifting it and pulling towards you. Note: the tank must be refitted in its position as soon as possible, to prevent the refrigerator from overheating. Fig. [. . . ]